Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 70)

3.2 Presetting automatically

8 Measured-value transfer (0, 1) Q303: Specify

whether the determined datum is to be saved in the

datum table or in the preset table:

0: Write determined datum in the active datum table.

The reference system is the active workpiece

coordinate system.

1: Write determined datum in the preset table. The

reference system is the machine coordinate system

(REF system).

8 Probe in TS axis Q381: Specify whether the TNC

should also set the datum in the touch probe axis:

0: Do not set datum in the touch probe axis

1: Set datum in the touch probe axis

8 Probe TS axis: Coord. 1. st axis Q382 (absolute):

Coordinate of the probe point in the reference axis of

the working plane at which point the datum is to be

set in the touch probe axis. Only effective if Q381 = 1.

8 Probe TS axis: Coord. 2. nd axis Q383 (absolute):

Coordinate of the probe point in the reference axis of

the working plane at which point the datum is to be

set in the touch probe axis. Only effective if Q381 = 1.

8 Probe TS axis: Coord. 3. rd axis Q384 (absolute):

Coordinate of the probe point in the reference axis of

the working plane at which point the datum is to be

set in the touch probe axis. Only effective if Q381 = 1.

8 New datum for touch probe axis Q333 (absolute):

Coordinate in the touch probe axis at which the TNC

should set the datum. Basic setting = 0

Example: NC blocks

5 TCH PROBE 409 SLOT CENTER STUD

Q321=+50 ;CENTER 1ST AXIS

Q322=+50 ;CENTER 2ND AXIS

Q311=25 ;RIDGE WIDTH

Q272=1 ;MEASURING AXIS

Q261=-5 ;MEASURING HEIGHT

Q320=0 ;SET-UP CLEARANCE

Q260=+20 ;CLEARANCE HEIGHT

Q305=10 ;NO. IN TABLE

Q405=+0 ;DATUM

Q303=+1 ;MEAS. VALUE TRANSFER

Q381=1 ;PROBE IN TS AXIS

Q382=+85 ;1ST CO. FOR TS AXIS

Q383=+50 ;2ND CO. FOR TS AXIS

Q384=+0 ;2RD CO. FOR TS AXIS

Q333=+0 ;DATUM

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 164 165

Comments to this Manuals

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 70

Comments to this Manuals

Related products and manuals for Equipment Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles