Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 150)

150

4.1 Tool Measurement with the TT Tool Touch Probe

Entries in the tool table TOOL.T

Abbr. Inputs Dialog

CUT Number of teeth (20 teeth maximum) Number of teeth?

LTOL Permissible deviation from tool length L for wear detection. If the

entered value is exceeded, the TNC locks the tool (status L). Input

range: 0 to 0.9999 mm

Wear tolerance: length?

RTOL Permissible deviation from tool radius R for wear detection. If the

entered value is exceeded, the TNC locks the tool (status L). Input

range: 0 to 0.9999 mm

Wear tolerance: radius?

DIRECT. Cutting direction of the tool for measuring the tool during rotation Cutting direction (M3 = –)?

R-OFFS For tool length measurement: Tool offset between stylus center

and tool center. Default setting: No value entered (offset = tool

radius)

Tool offset: radius?

L-OFFS Tool radius measurement: tool offset in addition to

offsetToolAxis between upper surface of stylus and lower

surface of tool. Default: 0

Tool offset: length?

LBREAK Permissible deviation from tool length L for breakage detection. If

the entered value is exceeded, the TNC locks the tool (status L).

Input range: 0 to 0.9999 mm

Breakage tolerance: length?

RBREAK Permissible deviation from tool radius R for breakage detection. If

the entered value is exceeded, the TNC locks the tool (status L).

Input range: 0 to 0.9999 mm

Breakage tolerance: radius?

1 2 ... 145 146 147 148 149 150 151 152 153 154 155 ... 164 165

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 150