Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 106)

106

3.3 Automatic Workpiece Measurement

Recording the results of measurement

For all cycles in which you automatically measure workpieces (with

the exception of Cycles 0 and 1), you can have the TNC record the

measurement results. In the respective probing cycle you can define

if the TNC is to

 Save the measuring log to a file.

 Interrupt the program run and display the measuring log on the

screen.

 Create no measuring log.

If you want to save the measuring log to a file, the TNC, by default,

saves the data as an ASCII file in the directory TNC:\..

Example: Measuring log for touch probe cycle 421:

Measuring log for Probing Cycle 421 Hole Measuring

Date: 30-06-2005

Time: 6:55:04

Measuring program: TNC:\GEH35712\CHECK1.H

Nominal values: Center in reference axis: 50.0000

Center in minor axis: 65.0000

Diameter: 12.0000

Given limit values: Maximum dimension for center in reference axis:

50.1000 Minimum limit for center in reference axis: 49.9000

Maximum limit for center in minor axis: 65.1000

Minimum limit for center in minor axis: 64.9000

Maximum dimension for hole: 12.0450

Minimum dimension for hole: 12.0000

Actual values: Center in reference axis: 50.0810

Center in minor axis: 64.9530

Diameter: 12.0259

Deviations:Center in reference axis: 0.0810

Center in minor axis: -0.0470

Diameter: 0.0259

Further measuring results: Measuring height: -5.0000

End of measuring log

All measured values listed in the log file are referenced to

the datum active during the respective cycle you are

running.

Use the HEIDENHAIN data transfer software TNCremo if

you wish to output the measuring log via the data

interface.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 164 165

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 106