26
2.1 Introduction
2.1 Introduction
Overview
The following touch probe cycles are available in the Manual mode:
Selecting probe cycles
8 Select the Manual Operation or Electronic Handwheel mode of
operation.
8 To select the touch probe functions, press the TOUCH
PROBE soft key. The TNC displays additional soft
keys—see table above
8 To select the probe cycle, press the appropriate soft
key, for example PROBING ROT, and the TNC
displays the associated menu.
Function Soft key Page
Calibrate the effective length Page 29
Calibrate the effective radius Page 30
Measure a basic rotation using a line Page 32
Set the datum in any axis Page 34
Set a corner as datum Page 35
Set a circle center as datum Page 36
Touch probe system data management Page 22
Comments to this Manuals