Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 27)

HEIDENHAIN TNC 320 27

2.1 Introduction

Writing the measured values from touch probe

cycles in datum tables

With the ENTER IN DATUM TABLE soft key, the TNC can write the

values measured after any touch probe cycle into a datum table active

for machine operation:

8 Select any probe function

8 Enter the desired coordinates of the datum in the appropriate input

boxes (depends on the touch probe cycle being run).

8 Enter the datum number in the Number in table= input box.

8 Enter the name of the datum table (complete path) in the Datum

table input box.

8 Press the ENTER IN DATUM TABLE soft key. The TNC saves the

datum in the indicated datum table under the entered number.

Use this function if you want to save measured values in

the workpiece coordinate system. If you want to save

measured values in the fixed machine coordinate system

(REF coordinates), press the ENTER IN PRESET TABLE

soft key (see “Writing the measured values from touch

probe cycles in the preset table” on page 28).

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 164 165

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 27