Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 50)

3.1 Measuring Workpiece Misalignment

8 First stud: Center in 1st axis (absolute): center of

the first stud in the reference axis of the working

plane.

8 First stud: Center in 2nd axis Q269 (absolute):

center of the first stud in the minor axis of the

working plane.

8 Diameter of stud 1 Q313: Approximate diameter of

the 1st stud. Enter a value that is more likely to be too

large than too small.

8 Measuring height 1 in the probe axis Q261

(absolute): Coordinate of the ball tip center (= touch

point in the touch probe axis) at which stud 1 is to be

measured.

8 Second stud: Center in 1st axis Q270 (absolute):

center of the second stud in the reference axis of the

working plane.

8 Second stud: Center in 2nd axis Q271 (absolute):

center of the second stud in the minor axis of the

working plane.

8 Diameter of stud 2 Q314: Approximate diameter of

the 2nd stud. Enter a value that is more likely to be

too large than too small.

8 Measuring height 2 in the probe axis Q315

(absolute): Coordinate of the ball tip center (= touch

point in the touch probe axis) at which stud 2 is to be

measured.

8 Setup clearance Q320 (incremental): Additional

distance between measuring point and ball tip. Q320

is added to column SET_UP.

8 Clearance height Q260 (absolute): Coordinate in the

touch probe axis at which no collision between tool

and workpiece (fixtures) can occur.

Q271

Q269

Q268 Q270

Q313

Q314

Q261

Q260

Q315

MP6140

Q320

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 164 165

Comments to this Manuals

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 50

Comments to this Manuals

Related products and manuals for Equipment Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles