Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 145)

HEIDENHAIN TNC 320 145

3.4 Special Cycles

8 Parameter number for result: Enter the number of

the Q parameter to which you want the TNC to assign

the first measured coordinate (X). The values Y and Z

are in the immediately following Q parameters.

8 Probing angle: Enter the angle in whose direction the

probe is to move and confirm with the ENT key.

8 Probing angle: Angle, measured from the probing

axis at which the touch probe is to move. Confirm

with ENT

8 Maximum measuring path: Enter the maximum

distance from the starting point by which the touch

probe is to move. Confirm with ENT.

8 Feed rate: Enter the measuring feed rate in mm/min.

8 Maximum retraction path: Traverse path in the

direction opposite the probing direction, after the

stylus was deflected. The TNC returns the touch

probe to a point no farther than the starting point, so

that there can be no collision.

8 REFERENCE SYSTEM (0=ACT/1=REF): Specify whether

the result of measurement is to be saved in the actual

coordinate system (ACT, can therefore be shifted or

rotated), or with respect to the machine coordinate

system (REF).

8 Error mode (0=OFF/1=ON): Specify whether the TNC

is to issue an error message if the stylus is deflected

at cycle start (0) or not (1). If you select mode 1, the

TNC continues to save the value 2.0 in the 4th result

parameter and continues the cycle.

8 To conclude the input, press the ENT key.

Example: NC blocks

4 TCH PROBE 3.0 MEASURING

5 TCH PROBE 3.1 Q1

6 TCH PROBE 3.2 X ANGLE: +15

7 TCH PROBE 3.3 DIST +10 F100 MB1

REFERENCE SYSTEM:0

8 TCH PROBE 3.4 ERRORMODE1

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 164 165

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 145