Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual download pdf (Page 129)

HEIDENHAIN TNC 320 129

3.3 Automatic Workpiece Measurement

8 Measuring axis Q272: Axis in the working plane in

which the measurement is to be made:

1:Reference axis = measuring axis

2:Minor axis = measuring axis

8 Measuring height in the touch probe axis Q261

(absolute): Coordinate of the ball tip center (= touch

point) in the touch probe axis in which the

measurement is to be made.

8 Setup clearance Q320 (incremental): Additional

distance between measuring point and ball tip. Q320

is added to column SET_UP.

8 Clearance height Q260 (absolute): Coordinate in the

touch probe axis at which no collision between tool

and workpiece (fixtures) can occur.

8 Nominal length Q311: Nominal value of the length to

be measured.

8 Maximum dimension Q288: Maximum permissible

length.

8 Minimum dimension Q289: Minimum permissible

length.

8 Measuring log Q281: Definition of whether the TNC is

to create a measuring log:

0: No measuring log

1: Generate measuring log: The TNC saves the log

file TCHPR426.TXT by default in the directory TNC:\

2: Interrupt the program run and display the

measuring log on the screen. Resume program run

with NC Start.

8 PGM stop if tolerance error Q309: Definition of

whether in the event of a violation of tolerance limits

the TNC is to interrupt the program run and output an

error message:

0: Do not interrupt program run, no error message

1: Interrupt program run, output an error message

8 Tool number for monitoring Q330: Definition of

whether the TNC is to monitor the tool (see “Tool

monitoring” on page 108)

0: Monitoring not active

>0: Tool number in the tool table TOOL.T

Example: NC blocks

5 TCH PROBE 426 MEASURE RIDGE WIDTH

Q263=+50 ;1ST POINT 1ST AXIS

Q264=+25 ;1ST POINT 2ND AXIS

Q265=+50 ;2ND POINT 1ST AXIS

Q266=+85 ;2ND POINT 2ND AXIS

Q272=2 ;MEASURING AXIS

Q261=-5 ;MEASURING HEIGHT

Q320=0 ;SET-UP CLEARANCE

Q260=+20 ;CLEARANCE HEIGHT

Q311=45 ;NOMINAL LENGTH

Q288=45 ;MAX. LIMIT

Q289=44.95 ;MIN. LIMIT

Q281=1 ;MEASURING LOG

Q309=0 ;PGM STOP IF ERROR

Q330=0 ;TOOL NUMBER

Q260

Q261

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 164 165

Comments to this Manuals

No comments

Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles User Manual Page 129

Comments to this Manuals

Related products and manuals for Equipment Heidenhain TNC 320 (340 55x-03) Touch Probe Cycles