HEIDENHAIN CNC PILOT 4290 37
1.6 DIN PLUS: Contours in the YZ Plane
Linear pattern in YZ plane, G481-Geo
G481 defines a linear pattern in the YZ plane. G481 is effective for the
figure defined in the following block (G380 to G385, G387).
Parameters
Q Number of figures
Y Starting point of pattern
Z Starting point of pattern
J End point of pattern (Y direction)
K End point of pattern (Z direction)
Ji Distance between two figures (in Y direction)
Ki Distance between two figures (in Z direction)
A Angle of longitudinal axis of pattern (reference: positive Z axis)
R Total length of pattern
Ri Distance between two figures (pattern distance)
Programming notes
Program the hole/figure in the following block without a
center.
The milling cycle (MACHINING section) calls the hole/
figure in the following block—not the pattern definition.
Comments to this Manuals