Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes User Manual download pdf (Page 13)

HEIDENHAIN CNC PILOT 4290 13

1.2 Manual Control and Automatic Modes

Adding tools to the magazine from the machine working space

Insert the tool in the tool holder and call the “Load plate” function.

Enter the ID number of the tool and the magazine pocket number. The

CNC PILOT inserts the tool in the magazine and enters the ID number

in the magazine list.

U Insert the tool in the tool holder (in the machine's working space).

U Select “T > Magazine > Load plate” in manual control mode. The

CNC PILOT opens the “Magazine: Load plate” dialog box.

U Enter the parameters and click OK to close the dialog box. The

control loads the associated NC program.

U Activate the NC program with Cycle Start.

The CNC PILOT

 inserts the tool in the magazine,

 enters the tool in the magazine list,

 moves the slide to the tool change position, and

 tilts the B axis,

Removing tools from the magazine

Remove the tool from the magazine and delete the entry in the

magazine list.

U Rotate the tool magazine to the corresponding position and remove

the tool.

U Select “Setting up > Tool list > Setup list” in manual control mode.

U Place the cursor on the magazine pocket of the tool you removed.

U Press the soft key or the DEL key and click yes on the

confirmation prompt. The control deletes the tool

from the magazine list.

1. 2.

3. 4.

ID . . .

P . . .

Parameters

ID ID number of the magazine tool.

P Pocket number in the tool magazine.

B B axis angle. Angle to which the B axis is tilted.

Note on operation and display: This function is executed

using an NC program. To activate the NC program, press

Cycle Start.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 118 119

No comments

Heidenhain CNC Pilot 4290 V7.1 Description of B and Y axes User Manual Page 13