Heidenhain MANUALplus 4110 User Manual download pdf (Page 248)

100

101

248 5 ICP Programming

5.2 Editing ICP Contours

Selection of solutions

If the entered data permit several possible solutions,

you can inspect the mathematically possible solutions

with Next solution / Continue solution and confirm

the correct solution with Select solution (see figures

at right).

Editing the last contour element

By pressing Change last, you can call the data of the

last entered contour element and edit it as desired.

Depending on the adjoining contour elements,

corrections of linear or circular elements are either

transferred immediately or the corrected contour is

displayed for inspection. Contour elements that have

been edited are highlighted in color. If the change

permits several possible solutions, you can check

all mathematically possible solutions with

Next solution / Continue solution.

The changes will not become effective until you press

Select solution. If you press Back, the change will

not be transferred and the previous description of the

last contour element becomes effective again.

The type of contour element (linear or circular

element), the direction of a linear element, or the

direction of rotation of a circular element cannot be

changed with this function. Should this be necessary,

you must delete the last contour element and add a

new contour element.

Deleting the last contour element

If you press Delete last, the data of the last entered

contour element are canceled. You can use this

function repeatedly to delete several successive

contour elements.

If the contour still contains unsolved

contour elements when you exit the

editing mode, MANUALplus will ask you

whether to cancel these elements.

1 2 ... 243 244 245 246 247 248 249 250 251 252 253 ... 549 550

Comments to this Manuals

No comments

Heidenhain MANUALplus 4110 User Manual Page 248

Comments to this Manuals

Related products and manuals for Equipment Heidenhain MANUALplus 4110