196 4 Cycle Programming
4.7 Drilling Cycles
Cycle run
1 Position spindle to "spindle angle C" (in Manual mode, machining
starts from the current spindle angle).
2 If defined, move at rapid traverse to
Z1 (axial).
X1 (radial).
3 Tap thread to
End point Z2 (axial).
End point X2 (radial).
4 If X1/Z1 has been defined, retract at return speed SR to
Starting point of hole Z1 (axial).
Starting point of hole X1 (radial).
If X1/Z1 has not not been defined, retract to
Starting point Z (axial).
Starting point X (radial).
Comments to this Manuals