Heidenhain ND 780 User Manual download pdf (Page 152)

28 I Operating Instructions

I - 2 General Operations for ND 780

Mirror

Edge Finder (milling applications only)

The diameter and length offset of the edge finder are set in this form.

Both values are in the units indicated in the form.

 The numeric keys are used to enter values of diameter and length.

The diameter must be greater than zero. The length is a sign value

(negative or positive).

 A soft key is provided to indicate the units of measure for the edge

finder.

The edge finder values will be retained on a power cycle.

Diameter Axes

Select Diameter Axes to set which axes can be displayed in either

radius or diameter values. ON indicates that the axis position will be

displayed as a diameter value. When OFF, the Radius/Diameter

feature does not apply. See . For turning applications see “RX

(Radius/Diameter) Soft Key” on page 79 for the Radius/Diameter

feature.

 Cursor to DIAMETER AXIS and press ENTER.

 The cursor will be in the X field. Depending on the parameter you

need for that axis press ON/OFF soft key to turn feature on or off.

 Press ENTER.

A scale factor of -1.00 will produce a mirror image of the

part. You can both mirror and scale a part at the same time

(see page 64).

1 2 ... 147 148 149 150 151 152 153 154 155 156 157 ... 246 247

No comments

Heidenhain ND 780 User Manual Page 152